Hi guys. New to sparky and really liking it.
I had a big problem the other day. Pretty much lost my new installation it seems. I'll be brief.
1) Installed sparky to a PC.
2) First time I booted it up, it ran fine. Spent about 4 hours getting it setup and customized, the apps I want etc.
3) Reboot. Sparky starts up, and does not get far until it crashes. The error message is really weird to me. I took a pic will my cellphone so will just re type the error messages:
[ok] Starting network connection manager: NetworkManager
[info] PulseAudio started: Configured for per-user session.
[ok] Enabling power management....done
Starting teamviewerd...method return org.freedesktop.dbus -> dest=:1.9 reply_serial-2
.........
The row of periods continue until about 10 periods then it stops, and nothing happens. Only key presses I found that does anything if I hit control-alt-delete which sends the TERM signal, where (I think) it drops to a terminal prompt. From here I typed 'startx' to see if that would do anything but something starts then it crashes (I'm a Linux noob).
I thought this was a really odd error so wanted to see if anyone had any ideas.
In the few hours I had the system going I don't think I did anything too radical to the configuration. The most possibly dangerous for stability problem thing I did was resizing my swap drive partition. I also did not use teamviewer at all, so again, weird that it crashes seemingly with something to do with that.
Hi
I don't think the teamviewer crased the system but you can removed it in recovery mode:
Code:
apt-get remove teamviewer
It's important what happend next.
You should check log files:
Code:
~HOME/.xsession-errors
and