SparkyLinux Forums

International board => Deutsch => Topic started by: jerry99 on May 01, 2020, 06:43:23 PM

Title: Hinweise zur Installation
Post by: jerry99 on May 01, 2020, 06:43:23 PM
Hallo liebes Sparky-Team.
Bin seit gestern im Forum angemeldet, nachdem ich Sparky schon auf 5 Rechnern installiert habe.
Dabei sind mir ein paar Sachen aufgefallen, die ich als änderungswürdig sehe.
Das soll nicht als Kritik aufgefasst werden, sondern als konstruktives Feedback

-   Bei der Installation dauert es für mich ungewöhnlich lange, bis es nach der Sprachauswahl weiter geht.
Ich wäre weniger verunsichert, wenn ein Fortschrittsbalken zu sehen wäre (ein ungeduldiger Freund - das stürzt ja gleich ab- probierte es einige Male, bis ich ihm weiter helfen konnte.
-   Die Sprachauswahl ist hier "Deutsch".
Nach der Installation kann die Installation weiterer Sprachmodule angefordert werden.
Hier ist die Auswahl "German"
-  wenn die Anzahl der Arbeitsflächen (Default 2) auf z.B. 6 vergrößert wird, kommen workspace1-4, Arbeitsfläche 5,6
Beim Update gibt es stets einen Fehler bei firmware-b43-installer und bei firmware-b43legacy-installer, der nicht weg zu bringen ist.
Macht weiterhin einen so guten Job TNX
Title: Re: Hinweise zur Installation
Post by: paxmark1 on May 02, 2020, 12:56:25 AM
Google translate   

Hello dear Sparky team.
Have been registered in the forum since yesterday after I installed Sparky on 5 computers.
I noticed a few things that I see as worth changing.
This should not be seen as criticism, but as constructive feedback

- During the installation, it takes an unusually long time for me to continue after selecting the language.
I would be less insecure if I could see a progress bar (an impatient friend - it crashes right away - tried it a few times until I could help him further).
- The language selection here is "German".
After the installation, the installation of additional language modules can be requested.
Here is the selection "German"
- if the number of work surfaces (default 2) is e.g. 6 is enlarged, come workspace1-4, workspace 5.6
With the update there is always an error with firmware-b43-installer and with firmware-b43legacy-installer, which cannot be removed.
Still doing such a good job Thanks. 


Have you looked at the recent posts about firmware-b43 here
Also possibly look at

Haben Sie sich hier die letzten Beiträge zu Firmware-b43 angesehen?
Möglicherweise auch anschauen

https://forum.siduction.org/index.php?topic=7948.msg64512#msg64512

NOTE: It is "bad form" to post there unless you are using Siduction (or possibly just Sid).  It is a good place to look for solutions if none are found here. 

HINWEIS: Es ist eine "schlechte Form", dort zu posten, es sei denn, Sie verwenden Siduction (oder möglicherweise nur Sid). Es ist ein guter Ort, um nach Lösungen zu suchen, wenn hier keine gefunden werden.

output of

"inxi -bnr"   output appreciated as always.

peace out.
Title: Re: Hinweise zur Installation
Post by: jerry99 on May 02, 2020, 10:03:23 AM
Danke für den Hinweis auf Siduction