SparkyLinux Forums

Software & hardware support => Newbie questions => Topic started by: crypto on December 15, 2017, 01:34:21 AM

Title: system config (nftables) [Solved]
Post by: crypto on December 15, 2017, 01:34:21 AM
so i was over on the Debian forms fist ... they don't want to help because i have this repo installed ..

Now the issue is that the command  sudo systemctl start | enable both fail ..

nftables dose not load ..... gives no error ...  yes i have a config made .. and it was working

this is the post there . http://forums.debian.net/viewtopic.php?f=5&t=135603

any ideas from here .... i have put sparky back as well .... using the newer kernel again ..
Title: Re: system config (nftables)
Post by: Capitain_Jack on December 17, 2017, 11:39:05 PM
As stated into the Debian Users forum, this was the solution, The program was running hidden, so issuing those commands helped (run as su or with sudo):

Try
    systemd-cgtop
Or
    ls -lR /etc/systemd/system
@crypto please, edit the first post title and add [SOLVED] to the title, thanks, other people can benefit from your problem and solution.
Title: Re: system config (nftables) [Solved]
Post by: crypto on July 20, 2018, 11:44:51 PM
sorry  lost  my net for a long while ....  couldn't update this ..

as it turns out ....   NFT was working fine .... they did an update and removed the nft from ps aux .....  so i didn't see it running, but i tested with a few probes, and other systems it was indeed working...