SparkyLinux Forums

Software & hardware support => Newbie questions => Topic started by: keos on December 08, 2021, 10:58:03 PM

Title: Systemback do not work properly.
Post by: keos on December 08, 2021, 10:58:03 PM
Hello,

I had to reinstall sparky7 ... I have a usb/systemback as a backup, with all settings etc.

The system had before breaking 7.5 GB approximately (amount with which it was copied to the usb) and when installing it now I see that it has practically doubled to 13 GB (?).

This is serious to me, because this system (systemback) does not accept to copy many GB, maybe up to 9 GB at most -- I would be left without Sparky because other tools like clonezilla etc, I simply do not understand them, I can not use them.

I have repeated the installation several times with the same result.

What could have happened?. And what, if anything, can be done to correct this.

Thanks for any hints,

Regards.

EDIT:

I thought it was some problem with 'testing', nothing to do with this, I installed Sparky stable now and i have the same problem, it doubles the total of the GB it has when you install the system  -- the problem is with Systemback.
When the system breaks I will not be able to reinstall it.
Title: Re: Systemback do not work properly.
Post by: keos on January 21, 2022, 04:47:12 PM
I found a way to copy/paste the whole system into a USB with Gparted  :)